ICLEBO Arte YCR-M05-P2 Manuel d'utilisation et d'entretien télécharger pdf (Page 14)

Cleaning Front-wheel

Click

1. Press the front-wheel fix clip with both hands and lift it up to separate.

2. Remove foreign substance on the front brush using the cleaning brush.

3. Pull out the front-wheel then clean dust and foreign

substances using the cleaning brush. As for the main

brush, remove the bearings to be able to easily remove

any hairs or foreign matter on the axle.

4. Put the front-wheel back and re-assemble as shown

in the method above.

※ Robot vacuum cleaner might not be working normally when the front and bottom cleaning robot sensors

are covered by a foreign substance. Cleaning and management is required for all sensors.

※ When disassembling the side brush, hold the whole

three strip brushes together at the same time and

pull it out.

1. Wipe the sensors on the front bumper of the robot

cleaner using cotton buds.

2. Wipe the sensors on the bottom of the robot cleaner

using cotton buds.

Cleaning Sensors

Cleaning Side-brush

1. Separate the side-brush with both hands.

2. Clean dust and foreign substance using the cleaning

brush.

● C A R E & M A I N T E NA N C E

1 2 ... 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

ICLEBO Arte YCR-M05-P2 Manuel d'utilisation et d'entretien Page 14